Miller Electric 500573 Hobart Handler 125, 120V Wire Feed Welder

• Four voltage ranges allow you to adjust the arc for different thicknesses
• Broad output range of 25–130 amps allows you to weld up to 1/8 in. steel with flux-cored wire
• Positive feed with adjustable tension gives you easy access to thread new wire
• Spool hub assembly accommodates 4- or 8-inch spools
• Built-in contactor safety feature makes wire electrically "cold" until trigger is pulled

The Handler 125 is a reliable constant-voltage DC welder with built-in wire feeder that operates on common 120-volt power. It comes ready to weld, without shielding gas, using .030–.035 inch (0.8–0.9 mm) self-shielding flux-cored wire. It can weld 24-gauge to 3/16-inch steel with flux-cored wire.

This welder is equipped with a factory-installed gas solenoid. With the addition of an optional regulator and shielding gas, you’re ready to MIG weld with .023–.030 inch (0.6–0.8 mm) solid wire in the traditional two-knob control mode. Use C-25 gas (75% argon/25% CO2) on 24 gauge–1/8 inch steel for a cleaner weld with less spatter. Use Tri-Mix gas and stainless wire for welding on 18–12 gauge stainless steel.

Processes:  MIG (GMAW), Flux Cored (FCAW)

Application:  Metal Fabrication, Maintenance and Repair, Auto Body, Farm/Home

Input Power:  120V

Amperage Range:  25-130 A

Rated Output:  80 A at 25% duty cycle; 50 A at 60% duty cycle; 40 A at 100% duty cycle

Max Wire Feed Speed:  545 ipm

Weight:  57.5

Dimensions:  10"(w) x 13.5"(h) x 19.4"(d)

Phase:  Single Phase

Includes:  8 ft. (2.4 m) H-9D gun | Liner for .030-.035 in. (0.8 -0.9 mm) diameter wire | work cable with clamp | two 0.030 (0.8 mm) contact tips | power cord with molded plug | weld set-up chart | owner's manual with installation, operation and maintenance guidelines

Click Here for the Hobart Handler 125 Spec Sheet



Click Here for Hobart Warranty Details